Backlight - auna multimedia Connect 120 Manual Del Usuario

Network
Network wizard
Enter to search AP SSID, then input the WEP/WPA key or choose Push Button/Pin/Skip WPS to connect to the wireless
network.
• PBC Wlan setup
Push Button Configuration, it is to connect the AP that supports WPS(Wi-Fi Protected Setup).
• View settings
View the information of current connected network: Active connection, MAC address, Wlan region, DHCP, SSID, IP
address, Subnet mask, Gateway address, Primary DNS and Secondary DNS.
• Wlan region
Select the Wlanregion to obtain the optimal Wlan connectivity: Canada, Spain, France, Japan, Singapore, Australia,
and Republic of Korea.
Manual settings
Choose network connection and enable or disable DHCP (Dynamic Host Configuration Protocol).
• Network profile
Unit remembers the last four wireless networks it has connected to, and automatically tries to connect to which
ever one of them it can find.
From here you can see the list of registered networks. You can delete unwanted networks by turning and pressing
then choosing YES to confirmdelete.
Time/Date
Set the time manually or auto update, time format, time zone and daylight.
Language
The default language is English. Change it as your preference.
Factory reset
A factory reset resets all user settings to default values, so that time and date, network configuration and presets are
lost. However, the unit's current software version is maintained, as is registration with the Internet radio portal. Inter-
net radio favourites therefore remain unless you re-register your unit with another account on the portal website.
Software update
From time to time, software upgrades may be created with bug fixes and/or additional features. You can either check
manually or set the unit to check periodically automatically (this is the default). If newer available software is detected,
you will be asked if you want to go ahead with an update. If you agree, the new software is then downloaded and ins-
talled. After a software upgrade, all user settings are maintained.
NOTE: Before starting a software upgrade, ensure that unit is plugged into a stable main power connection. Discon-
necting power during an upgrade may permanently damage the unit.
Info
View the firmware version and the radio ID.

Backlight

You may change the backlight of each environment (power on or standby) to High, Medium or Low.And adjust the
timeout duration which the radio turns to standby backlight level when it has not been controlled.
27