auna multimedia Connect 120 Manual Del Usuario página 33

FM radio mode receives analogue radio from the FM band and displays RDS (Radio Data System) information about
the station and where broadcast.
To find a station, press SELECT. The frequency display starts to run up as unit scans the FM band. Alternatively, you
can scan up or down by pressing and holding the buttons
NAVIGATE.
5.7.1Preset
To store a FMpreset, press and hold PRESET until the display shows the Save preset screen. Select one of the 10 pre-
sets to save the currently playing station (confirm pressing NAV/OK).
To select a preset, press PRESET briefly, then select one of the listed preset stations. When a preset station is playing,
it shows Pn (P1, P2 etc) at the bottom right of the screen.
P1 to P10 on the remote control are for the use ofpreset station1-10.
Now playing information
While the stream is playing, the screen shows its frequency, or if RDS information is available, station name and any
further RDS information such as programme name, track title and contact details. If no informationis available, just the
frequency is shown. Stereo broadcasts are indicated with an icon at the top of the screen, To view further information
about the broadcast, press INFO.
Each time you press INFO, another set of information is displayed, cycling through RDS text, further RDS text (station/
programme type), frequency and today's date.
Settings
• Scan settings
By default, FM scans stop at any available station. This may result in a poor signal-to-noise ratio (hiss) from weak
stations. To change the scan settings to stop only at stations with good signal strength, select Yes after choosingS-
trong station only?
• Audio settings
All stereo stations are reproduced in stereo. For weak stations, this may result in a poor signal-to-noise ratio (hiss).
To play weak stations in mono, select FM weak reception: Listen in mono only and then YES.
FM
or or tune manually with quick presses or by turning
33