Safety Instructions - Mafell KSS40 18 M bl Traducción Del Manual De Instrucciones Original

3

Safety instructions

Danger
Always observe the following safety
instructions and the safety
regulations applicable in the
respective country of use!
General instructions:
- Children and adolescents must not operate this
machine. This rule does not apply to young
persons receiving training and being supervised by
an expert.
- Never work without the protection devices
stipulated for the respective operating sequence
and do not effect any modifications on the machine
that could impair safety.
- Protect the machine and the rechargeable
batteries from humidity!
- Do not throw the rechargeable batteries into a fire!
- Do not use any
rechargeable batteries!
- Do not open the rechargeable batteries!
- Do not touch the contacts of the rechargeable
batteries and do not short-circuit them!
- A slightly acidic, combustible liquid may leak from
defective li-ion rechargeable batteries! If any
battery liquid is leaking and comes in contact with
the skin, immediately rinse with a copious amount
of water. If any battery liquid gets into your eyes,
rinse with clean water and immediately consult a
doctor for medical treatment!
- Remove the rechargeable batteries from the
machine before carrying out any setting, retooling,
maintenance or cleaning tasks.
- Ensure that the machine is switched off when you
push in the rechargeable battery.
- Please remove the rechargeable battery from the
machine if the machine is put down, transported or
stored unattended.
defective or deformed
Do not use:
- Cracked and misshapen saw blades.
- Saw blades made of high speed steel (HSS saw
blades).
- Blunt saw blades as they impose an excessive
load on the motor.
- Saw blades with a base body with a thickness
greater than, or a cutting width (setting) less than,
the thickness of the riving knife / splitter.
- Saw blades which are not suitable for the saw
blade's idling speed.
- Grinding discs
Instructions on the use of personal protective
equipment:
- Always wear ear protectors during work.
- Always where a dust mark during work.
Instructions on operation:
Sawing method
Danger
- Keep hands away from cutting area and the
blade. Keep your second hand on auxiliary
handle, or motor housing. If both hands are
holding the saw, they cannot be cut by the blade.
- Do not reach underneath the workpiece. The
guard cannot protect you from the blade below the
workpiece.
- Adjust the cutting depth to the thickness of the
workpiece. Less than a full tooth of the blade
teeth should be visible below the workpiece.
- Never hold the workpiece in your hands or
across your leg while cutting. Secure the
workpiece to a stable platform. It is important to
support the work properly to minimise body
exposure, blade binding, or loss of control.
-23-