Safety Instructions For Installation And Maintenance Work; Unauthorised Modification And Manufacture Of Spare Parts; Improper Use; Transport And Interim Storage - salmson PRIUX MASTER-D 32-90 Instalacion Y Puesta En Servicio

English
2.6

Safety instructions for installation and maintenance work

The operator must ensure that all installation and maintenance work is carried out by
authorised and qualified personnel, who are sufficiently informed due to their own
detailed study of the operating instructions.
Work to the product/unit must only be carried out when at a standstill. It is mandatory that
the procedure described in the Installation and operating instructions for shutting down
the product/unit be complied with.
Immediately on conclusion of the work, all safety and protective devices must be put back
in position and/or recommissioned.
2.7

Unauthorised modification and manufacture of spare parts

Unauthorised modification and manufacture of spare parts will impair the safety of the
product/personnel and will make void the manufacturer's declarations regarding safety.
Modifications to the product are only permissible after consultation with the manufac-
turer. Original spare parts and accessories authorised by the manufacturer ensure safety.
The use of other parts will absolve us of liability for consequential events.
2.8

Improper use

The operating safety of the supplied product is only guaranteed for conventional use in
accordance with Section 4 of the operating instructions. The limit values must on no
account fall under or exceed those specified in the catalogue/data sheet.

3 Transport and interim storage

On arrival, immediately check the product and its packaging for damage caused during
transit. If damage is found, the necessary procedures involving the forwarding agent must
be taken within the specified period.
CAUTION! Risk of injuries to personnel and property damage!
Incorrect transport and interim storage can cause damage to the product and injury to
personnel.
• The pump and its packaging must be protected against moisture, frost and mechanical
damage during transport and interim storage.
• Packaging that has become weakened due to moisture may allow the product to fall
out, causing injury to personnel.
• When the pump needs to be transported, it may be carried only by the motor/pump
housing. Never by the control module or cable.

4 Intended use

The high-efficiency pumps of the Priux master/-D series are for the circulation of liquids
(no oils or liquids containing oil, no media containing foodstuffs) in
• hot water heating systems
• cooling and cold water circuits
• closed-circuit industrial circulation systems
• solar installations
WARNING! Health hazard!
Because of the materials used in their construction, pumps of the Piux master/-D
series must not be used in applications involving potable water or foodstuffs.
26 Pompes Salmson 02/2013