Infosec E3 PERFORMANCE 5000VA Manual De Usuario página 38

Step 6 - External battery connection
Connect the external battery modules to the UPS thanks to an optional battery connector (in
case of extended backup time).
CAUTION: Connection to External Battery Pack shall be installed by SERVICE
PERSONNEL only.
To connect an external battery pack:
1. Turn off the UPS utility input.
2. Open the front-left cover on the UPS and the battery modulefirst. And disconnect the
internal battery cable.
3. Remove the external battery covers from the UPS and the battery pack. Connect one end
of the external battery cable to the UPS and the other end to the battery pack as shown in
Figure above.
If connecting more than one external battery pack please use one more battery cable to
connect battery pack #1 and battery pack #2 as shown in Figure above.
4. Once the UPS and external battery packs are connected, secure the connection with the
screws. Then, re-connect the internal battery cable and put all front-left covers back to the
units.
NOTE 1 : After installation and initial start-up, set the numbers of installed battery pack first.
Please refer to the details in the "UPS Settings" section.
NOTE 2 : When 2 or more external battery packs are used, the UPS output rating is derated
20%.
Step 7 - Turn on the UPS

Press the ON/Mute button on the front panel for two seconds to power on the UPS.
Note: The battery charges fully during the first five hours of normal operation. Do not expect
full battery run capability during this initial charge period.
Step 8 - Install software

For optimal computer system protection, refer to the InfoPower software CD to fully
configure UPS shutdown.
For more information, refer to the communication software user's manual.
2.5.a Battery replacement
When the icons of
seconds, it's time to replace batteries. Contact your service representative to replace
INFOSEC UPS SYSTEM - 15, rue du Moulin - 44880 Sautron - FRANCE - www.infosec-ups.com
38
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)240 94 29 51 - hotline@infosec.fr – 12 18 AA 59 205 19
UPS
and are flashing in LCD display and alarm is sounding every 2
Battery module
Battery module