Instrucciones Importantes De Seguridad - DigiTech TIME BENDER Manual De Instrucciones

INSTRUCCIONES IMPORTANTES DE SEGURIDAD

Los símbolos mostrados arriba son un standard internacional que
advierte de los posibles riesgos de los aparatos eléctricos. el rayo dentro
del triángulo equilátero advierte de la existencia de voltajes peligrosos
presentes dentro de la unidad. el símbolo de exclamación dentro del
triángulo equilátero indica que es necesario que el usuario consulte el
manual de instrucciones.
estos símbolos advierten también que este aparato no contiene ninguna
pieza susceptible de ser reparada por el propio usuario. No abra la unidad.
No trate de reparar la unidad por sus propios medios. dirija cualquier
posible reparación al aservicio técnico oficial. el abrir el chasis por cualquier
razón anulará la garantía el fabricante. No permita que esta unidad se
humedezca. si se derrama cualquier líquido sobre esta unidad, apáguela
de inmediato y llévela al servicio técnico o distribuidor. desconecte esta
unidad de la corriente durante las tormentas eléctricas para evitar daños.
Safety InStructIonS
Notice For customers iF Your uNit is equipped With A poWer cord.
WArNiNG: this AppLiANce shALL Be coNNected to A mAiNs socKet outLet With A
protectiVe eArthiNG coNNectioN.
the cores in the mains lead are coloured in accordance with the following code:
GREEN and YELLOW - Earth BLUE - Neutral
As colours of the cores in the mains lead of this appliance may not correspond with the
coloured markings identifying the terminals in your plug, proceed as follows:
• the core which is coloured green and yellow must be connected to the terminal in the
plug marked with the letter e, or with the earth symbol, or coloured green, or green
and yellow.
• the core which is coloured blue must be connected to the terminal marked N or coloured
black.
• the core which is coloured brown must be connected to the terminal marked L or
coloured red.
this equipment may require the use of a different line cord, attachment plug, or both,
depending on the available power source at installation. if the attachment plug needs to
be changed, refer servicing to qualified service personnel who should refer to the table
below. the green/yellow wire shall be connected directly to the units chassis.
CONDUCTOR
L LIVE
N NEUTRAL
E EARTH GND
WARNING: if the ground is defeated, certain fault conditions in the unit or in the system
to which it is connected can result in full line voltage between chassis and earth ground.
severe injury or death can then result if the chassis and earth ground are touched
simultaneously.
BROWN - Live
WIRE COLOR
Normal Alt
BROWN BLACK
BLUE WHITE
GREEN/
GREEN
YEL
WarnInG for your ProtectIon
reaD tHe foLLoWInG:
KEEP THESE INSTRUCTIONS
HEED ALL WARNINGS
FOLLOW ALL INSTRUCTIONS
THE APPARATUS SHALL NOT BE ExPOSED TO DRIPPING OR SPLASHING LIqUID
AND NO OBjECT FILLED WITH LIqUID, SUCH AS vASES, SHALL BE PLACED ON
THE APPARATUS
CLEAN ONLY WITH A DRY CLOTH.
DO NOT BLOCK ANY OF THE vENTILATION OPENINGS. INSTALL IN ACCORDANCE
WITH THE MANUFACTURER'S INSTRUCTIONS.
DO NOT INSTALL NEAR ANY HEAT SOURCES SUCH AS RADIATORS, HEAT REGISTERS,
STOvES, OR OTHER APPARATUS (INCLUDING AMPLIFIERS) THAT PRODUCE HEAT.
ONLY USE ATTACHMENTS/ACCESSORIES SPECIFIED BY THE MANUFACTURER.
UNPLUG THIS APPARATUS DURING LIGHTNING STORMS OR WHEN UNUSED FOR
LONG PERIODS OF TIME.
do not defeat the safety purpose of the polarized or grounding-type plug. A polarized
plug has two blades with one wider than the other. A grounding type plug has two
blades and a third grounding prong. the wide blade or third prong are provided for
your safety. if the provided plug does not fit your outlet, consult an electrician for
replacement of the obsolete outlet.
protect the power cord from being walked on or pinched particularly at plugs,
convenience receptacles, and the point where they exit from the apparatus.
use only with the cart stand, tripod bracket, or table specified by the manufacture,
or sold with the apparatus. When a cart is used, use caution when moving the cart/
apparatus combination to avoid injury from tip-over.
refer all servicing to qualified service personnel. servicing is required when the apparatus
has been damaged in any way, such as power-supply cord or plug is damaged, liquid
has been spilled or objects have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally, or has been dropped.
POWER ON/OFF SWITCH: For products provided with a power switch, the power
switch does Not break the connection from the mains.
MAINS DISCONNECT: the plug shall remain readily operable. For rack-mount or
installation where plug is not accessible, an all-pole mains switch with a contact
separation of at least 3 mm in each pole shall be incorporated into the electrical
installation of the rack or building.
FOR UNITS EqUIPPED WITH ExTERNALLY ACCESSIBLE FUSE RECEPTACLE: replace
fuse with same type and rating only.
MULTIPLE-INPUT vOLTAGE: this equipment may require the use of a different line
cord, attachment plug, or both, depending on the available power source at installation.
connect this equipment only to the power source indicated on the equipment rear
panel. to reduce the risk of fire or electric shock, refer servicing to qualified service
personnel or equivalent.