Simple-Wifi Configuration; Connection In Simple-Wifi Mode; Local Configuration - Hayward WIFI SmartTemp 2 Instrucciones De Servicio

4. SIMPLE-WIFI CONFIGURATION

With Simple-WiFi mode you can connect to the heat pump locally, i.e. by using the
WiFi signal transmitted by the SMART TEMP 2 module. This mode is only available if
your mobile device is within the range of the module's Simple-WiFi network. Using the
SMART TEMP 2 application on your telephone you can therefore connect to the heat
pump and access the user interface.
Note: This manual is not intended to explain the operation of the Smart Temp 2
application, for that we recommend that you read the instructions for use
included in the application.

4.1 Connection in Simple-WiFi mode

• Ensure that the power to the heat pump is on, then follow the steps below
2 s

4.2 Local configuration

• Before starting the configuration, download the Smart Temp 2 application.
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
WIFI SmartTemp 2 module Page 7 on 13