Restarting A Warm Engine - Powermate P-RTT-196MD Manual Del Operador

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

Operation

• Save all instructions

Pre-Start Inspection

1. Make sure all safety guards are in place and all nuts and

bolts are secure.

2. Check oil level in engine crankcase. See your engine

manual for procedure and specifications.

3. Inspect air cleaner for cleanliness. See your engine

manual for procedure.

4. Check the fuel supply. Fill the fuel tank no closer than 1

inch from top of tank to provide space for expansion. See

your engine manual for fuel recommendations.

5. Be sure spark plug wire is attached and spark plug is

tightened securely.

6. Check position of wheels and wheel lockouts.

7. Check depth regulator lever position.

8. Examine underneath and around engine for signs of oil or

fuel leaks.

9. Inspect fuel hoses for tightness and fuel seepage.

10. Look for signs of engine damage.

11. Remove excessive debris from muffler area and recoil

starter.

ENGINE IS SHIPPED FROM FACTORY WITHOUT

IMPORTANT:

OIL. YOU MUST ADD ENGINE OIL BEFORE STARTING

ENGINE.

Start-Up

The controls required to start and run the tiller are located on the engine and are marked with the icon for choke, slow and fast

for the throttle, and on/off fuel valve. A more detailed description of engine operation and all related precautions and procedures

can be found in the engine manufacturer's manual that accompanies each tiller.

COLD STARTS

1. Turn the Engine Switch to the "on" position.

2. Open the Fuel Valve.

3. Move choke lever to left for full choke position.

4. Move throttle lever to "start" or "fast" position.

5. Pull starting rope out slowly one time and allow to return

normally.

6. Pull starting rope out rapidly, and allow rope to return

normally.

7. When engine starts, gradually move choke lever to "no

choke" position and increase throttle speed.

Questions? Call Toll Free at 1-800-737-2112

CAUTION

PLEASE DO NOT START YOUR TILLER UNTIL YOU HAVE READ

THE MANUAL THAT CAME WITH YOUR TILLER, AND THE SEC-

TIONS IN THIS MANUAL TILLER CONTROLS, ADJUSTMENTS

AND SAFETY. IF YOU HAVE READ THESE, FOLLOW THE STEPS

bELOW TO START YOUR TILLER. ALWAYS PERFORM THIS

PRE-START CHECkLIST bEFORE STARTING THE ENGINE.

WARNING

GASOLINE IS HIGHLY FLAMMAbLE AND MUST bE HANDLED

WITH CARE. NEVER FILL THE TANk WHEN THE ENGINE IS HOT

OR RUNNING. ALWAYS MOVE OUTDOORS TO FILL TANK.

WHEELS MUST ALWAYS bE LOCkED IN THE TILLING POSITION

WHEN ENGINE IS RUNNING. DO NOT OPERATE THE TILLER

WITH THE WHEEL LOCkOUTS UNLOCkED. ALWAYS SET THE

WHEELS IN TILLING POSITION bEFORE STARTING ENGINE.

ALWAYS PUT DEPTH REGULATOR LEVER IN THE TRANS-

PORT POSITION bEFORE STARTING ENGINE. TINES SHOULD

CLEAR GROUND.

DANGER

ALWAYS kEEP HANDS AND FEET CLEAR OF ROTATING MA-

CHINE PARTS.