Section I Safety
Warnings
Make sure you read and understand all instructions and safety precautions
listed in this manual before installing or operating your circulator. If you have
any questions concerning the operation of your circulator or the information in
this manual, contact our Sales Department (see After-sale Support).
Performance of installation, operation, or maintenance procedures
other than those described in this manual may result in a hazardous
situation and may void the manufacturer's warranty.
Transport the circulator with care. Sudden jolts or drops can damage
the refrigeration lines.
Observe all warning labels.
Never remove warning labels.
Never operate damaged or leaking equipment.
Never operate the circulator without cooling fluid in the bath.
Always turn off the circulator and disconnect the line cord from the
power source before performing any service or maintenance proce-
dures, or before moving the circulator.
Always empty the bath before moving the circulator.
Never operate equipment with damaged line cords.
Refer service and repairs to a qualified technician.
For proper travel, the compressors' support springs are tightened prior
to shipping. The springs (four per compressor) must be loosened
before operating the circulator. Remove the rear and side panels for
easy access to the compressors and springs.
In addition to the safety warnings listed above, warnings are posted
throughout the manual. These warnings are designated by an exclamation
mark inside an equilateral triangle with text highlighted in bold print. Read
and follow these important instructions. Failure to observe these instructions
can result in permanent damage to the circulator, significant property damage,
or
personal injury or death.
- 4 -