Sammic HM-2000 Instrucciones De Uso página 18

Not suitable for microwave cooking:
METAL UTENSILS
Metal utensils are not recommended because the metal shields the food from
microwave energy on the bottom and sides, causing uneven cooking result.
Metal utensils will also cause arcing and damage to the appliance.
ADORNOS METÁLICOS
No deben utilizarse pucheros, vajilla, etc. con cercos o adornos metálicos, ya
que éstos impiden que la cocción se realice normalmente, pudiendo producir-
se daños materiales.
METAL DECORATION
Metal-trimmed or banded dinnerware, casseroles, etc., should not be used. The
metal trim interferes with normal cooking and damage may result.
ALUMINUM FOIL
Large sheets or pieces of aluminum foil should be avoided because they will
disrupt cooking and may cause harmful arcing. However, smaller pieces may
CHECKING ACCUMULATIVE COOKING TIME, NUMBER OF DOOR OPERATIONS AND CONTROL OF THE BUZZER SOUND
Display shows accumulative cooking time or the number of door operations by key operation. Also, you can change any remaining cooking time, buzzer sound or
buzzer volume.
· Stages 1 to 3 are the same for all options. Input the 4th digit as follows to check or change the modes.
18 ENGLISH
Operation
· Touch key.
· Touch key.
· Touch number "8" three times.
· Input one of the following options (1-0) using
the PROGRAMME SELECTION key.
· Touch key.
· Touch key again.
· Touch key.
be used to cover areas such as poultry legs and wings. Any aluminum foil use
should never be closer than 1 inch from side walls of oven.
WOOD
Wooden bowls and boards will become dried out when used in the microwave
oven and may split or crack.
OTHER
Avoid using cracked, flawed, or defective utensils, including ovenproof glass-
ware.
CAUTION: DO NOT USE METAL TIES ON ANY PAPER OR PLASTIC BAGS;
THE TIES BECOME HOT AND COULD CAUSE A FIRE.
Display window
· "0" appears in the display.
· The colon an Power level "10" bar appe-
ar in the display.
· The "8:88" appears in the display.
· e.g. Input "1" (accumulative cooking
time).
· All 4 digits will be flashing.
· The number "215" shows total cooking
hours OR.
· In case where options other than 1 or 2
were selected in stage 4, "0" appears in
the display confirming that the new set-
ting has been accepted.
· In case of option 1 or 2, the CLEAR key must
be touched to clear the display. (not necessary
for optios 3 to 0).