Publicidad
Idiomas disponibles
Idiomas disponibles
TO LEVEL MOWER
Make sure tires are properly
inflated to the
PSI shown ontires.
If tires are over or under
inflated, it may affect the appearance
of your
lawn and lead you to think the mower is not
adjusted
properly.
VISUAL SIDE-TO-SIDE
ADJUSTMENT
1. With all tires properly
inflated and if your
lawn appears
unevenly
cut, determine
which side of mower is cutting lower.
2. With a 3/4" or adjustable
wrench, turn lift
link adjustment
nut (A) to the left to lower
LH side of mower, or, to the right to raise
LH side of mower.
NOTE: Each full turn of adjustment
nut wilt
change mower height about 3/16".
Turn nut ri
Turn nut left
to raise mower
to lower mower
3. Test your adjustment
by mowing
some
uncut grass
and visually checking
the
appearance.
Readjust,
if necessary, until
you are satisfied with the results.
PRECISION
SIDE-TO-SIDE
ADJ USTMENT
1. With all tires properly inflated, park tractor
on level ground or driveway.
CAUTION:
Blades
are sharp.
Protect
your hands with gloves and/or wrap blade
with heavy cloth.
2. Raise mower to its highest position.
3. At both sides of mower, position blade at
side and measure
the distance
(A) from
bottom edge of blade to the ground. The
distance
should
be the same on both
sides.
4. If adjustment
is necessary,
see step 2 in
V_sual Adjustment
instructions
above.
5. Recheck measurements,
adjust if neces-
sary until both sides are equal.
At
21
FRONT-TO-BACK ADJUSTMENT
IMPORTANT:
Deck
must
be level
side-
to-side.
To obtain the best cutting results, the mower
blades should be adjusted
so the front tip is
1/8" to 1/2" lower than the rear tip when the
,_ower is in its highest
position.
CAUTION:
Blades
are sharp.
Protect
your hands with gloves and/or wrap btade
with heavy cloth.
• Raise mower to highest
position.
• Position
any blade so the tip is pointing
straight
forward,
Measure
distance
(13)
to the ground at front and rear tip of the
blade.
• If front tip of blade is not 1/8" to 1/2" lower
than the rear tip, go to the front of tractor.
• With
an 11/16"
or adjustable
wrench,
loosen
jam nut A several
turns to clear
adjustment
nut B.
• With a 3/4" or adjustable wrench, turn
front link adjustment nut (B) clockwise
(tighten) to raise the front of mower, or,
counterclockwise (loosen) to lower the
front mower.
Tighten adjust nut
Loosen adjust
B to raise mower
nut B to lower
mowel"
Loosen jam nut A first
NOTE: Each full turn of the adjustment nut
willchange mower height about 1/8%
• Recheck measurements, adjust if neces-
sary until front tip of blade is 1/8" to t/2"
bowerthan the rear tip.
• Hold adjustment nutin position with wrench
and tighten jam nut securely against ad-
justment nut.
Publicidad
