Publicidad
Idiomas disponibles
Idiomas disponibles
REPLACING
BA'I-I'ERY
n_asWARNING:
Do not short battery termi-
by altowi nga wrench o r any other object
to contact
both terminals
at the same time.
Before
connecting
battery,
remove
metal
bracelets,
wristwatch
bands, rings, etc.
Positive terminal
must be connected
first to
prevent sparking from accidental
g rounding.
1. Lift seat pan to raised position.
2.
Remove terminal
cover,
3, Disconnect
BLACK
battery
cable then
RED battery cable and carefully remove
battery from tractor,
4. Install new battery with termtnals _nsame
position
as old battery.
5. Reinstall
terminal
cover.
6. First connect
RED battery cable to posi-
tive (+) battery terminal wtth bolt and nut
as shown, Tighten
securely.
7. Connect
BLACK
grounding
cable
to
negative
(-) batteryterminal
with remain-
ing bolt and nut. Tighten securely
8. Lower seat pan.
Terminal
Ceverx
Negative
(Black)
Nut
Bolt
Positive
(Red)
TO REPLACE FUSE
Replace with 30 amp automotive-type plug-
in fuse, The fuse holder is located behind
the dash.
TO REMOVE
HOOD AND GRILL
ASSEMBLY
1. Raise hood.
2. Unsnap
headlight
wire connector.
3. Stand in front of tractor.
Grasp hood at
sides,
tilt toward
engine
and lift off of
tractor.
4. When replacing
hood, ensure to recon-
nect the headlight
wire connector.
Headlight
Wire
Connector
ENGINE
TO ADJUST THROTI-LE CONTROL
CABLE
The throttle control has been preset at
the factory and adjustment should not be
necessary Check adjustment as described
below before loosening cable. Ifadjustment
is necessary, see engine manual.
TO REPLACE
HEADLIGHT
BULB
1. Raise hood.
2. Remove
bulb holder from the hole in the
backstde
of the grill.
3. Replace
bulb m holder and install bulb
holder securely
back into the hole in the
backside
of the grill.
4. Close hood.
INTERLOCKS
AND RELAYS
Loose or damaged
wiring
may cause your
tractor to run poorly, stop running, or prevent
it from starting.
• Check wiring.
TO ADJUST
CHOKE
CONTROL
The
choke
control
has been
preset
at
the factory
and adjustment
should
not be
necessary.
If adjustment
is necessary,
see
engine manual.
TO ADJUST
CARBURETOR
You r carburetor has been preset at the factory
and adjustment
should
not be necessary.
However, m=nor adjustment
may be required
to compensate
for differences
in fuel, tem-
perature, altitude or load. If the enginedoes
need adjustment,
see engine manual.
24
Publicidad
