Publicidad
Idiomas disponibles
Idiomas disponibles
TRANSAXLE
GEAR SHIFT
LEVER NEU-
TRAL ADJUSTMENT
The transaxle should be in neutral when the
gear shift lever is in neutral
(N) (lock gate)
position.
The adjustment
is preset
at the
factory;
however,
if adjustment
is needed,
proceed
as follows:
1. Ensure transaxle
is in neutral
(N).
NOTE: When the tractor rear wheels move
freely, the transaxle
is in neutral.
2. Loosen
adjustment
bolt in front of the
right rear wheeL.
3. Position the gear shift lever in the neutral
(N) position.
4. Tighten
adjustment
bolt securely.
NOTE:
If additional
clearance
is needed to
get to adjustment
bo]t, move
mower deck
height to the lowest position.
Gearshift Lever
Neutral
Lock
Adjustment Bolt
Gate
TO REMOVE
WHEEL
FOR REPAIRS
1. Block up axle securely.
2. Remove
axle cover, retaining
ring and
washers
to allow wheel
removal
(rear
wheels have a square key - Do net lose).
3. Repair tire and reassemble.
NOTE: On rearwheels
only: align grooves in
rearwheel
hub and axle. Insert square key.
4. Replace washers and snap retaining ring
securely
in axle groove.
5. Replace axle cover.
NOTE:
To seal tire punctures
and prevent
flat tires due to slow leaks,
purchase
and
use tire sealant from Sears. Tire sealant also
prevents tire dry rot and corrosion.
Retaining
#
Axle Cover
"_8qu;_re
Key (Rear
Wheel On]y)
FRONT WHEEL TOE-IN/CAMBER
Your new tractor front wheel toe-in and
camber is set at the factory and is normal,
The front wheel toe-in and camber are not
adjustable.
If damage has occurred to
affect the factory set front wheel toe-in or
camber, contact a Sears or other qualified
service center.
TO START ENGINE WITH A WEAK BAT-
"FIERY
_WARNING:
Lead-acid
batteries
gener-
ate explosive
gases.
Keep sparks,
flame
and smoking
materials
away from batteries.
Always wear
eye protection
when around
batteries.
If your battery is too weak to start the engine,
it should be recharged.
(See "BATTERY"
in
the MAINTENANCE
section of this manual).
If "jumper
cables" are used for emergency
starting, follow this procedure:
IMPORTANT:
Your tractor is equipped with
a 12 volt system. The other vehicle must also
be a 12 volt system. Do not use your tractor
battery to start other vehicles.
TO ATTACH JUMPER
CABLES
-
1. Connectoneend
ofthe RED cabletothe
POSITIVE
(+) terminal of each battery(A-
B), taking care notto short againsttractor
chassis.
2. Connect
one end of the BLACK
cable
to the NEGATIVE
(-) terminal (C) of fully
charged
battery.
3. Connect
the other end of the BLACK
cable (D) to good chassis ground,
away
from fuel tank and battery.
TO REMOVECABLES,
REVERSEORDER-
1. BLACK cabIe first from chassis and then
from the fully charged
battery.
2. RED cable last from both batteries,
Weak or Dead
Fully Charged
Battery
Battery
23
Publicidad
