Cable Assembly; Torch Neck - Abicor Binzel RB/RP Serie Instructivo De Servicio

8 Maintenance and cleaning

8.1 Cable assembly

8.2 Torch neck

EN - 10
1 Unscrew the cable assembly on the machine side and bring it into a
stretched position.
2 Unscrew retaining sleeve and pull out liner and replace it, if necessary.
3 Remove worn parts from the torch neck.
WARNING
Risk of injury
Serious injuries caused by parts swirling around.
• When cleaning the wire guide liner with compressed air, wear suitable
protective clothing, in particular safety goggles.
4 Clean wire conduit from both sides with compressed air.
5 Slide adjusted liner into wire conduit and secure with retaining sleeve.
6 Connect cable assembly on the machine side with wire feed unit.
1 Remove gas nozzle.
2 Remove welding spatter and spray gas nozzle using the ABICOR BINZEL
anti-spatter agent.
3 Check wearing parts for visible damage and replace them, if required.
MAG Welding torches