Using Your Press & Refresh - Shark Press & Refresh GS500 Serie Manual Del Usario

Using Your Press & Refresh
Always check the fabric Practice makes perfect! It
labels for recommendations takes time to get used to
from the manufacturer. and master the garment
Test the fabric in an steaming techniques.
inconspicuous part of the
garment such as an inner
seam.
Fig. 1
Filling and refilling the water Attaching the accessories:
reservoir:
3 C hoose your desired frame. The
1 N ever fill the fabric steamer
point of the frame should be
while it is plugged into an pointed down. Attach the top
electrical outlet. Disconnect the flat area of the frame to the
power cord before refilling. unit and then gently push the
pointed end of the frame on
2 O pen the water cap and hold
securely. (Fig. 2)
the fabric steamer horizontally
and fill using the filling flask When using the upholstery/
provided. Be careful not to delicate fabric frame:
overfill. Replace the cap by
4 A ttach the desired bonnet to
pushing it in making sure that it
the frame, then attach the
closes firmly. (Fig. 1)
frame to the unit. Pull the
NOTE: The water tank does not 2 tabs on either side of the
have to be completely full for bonnet over the top of the
the fabric steamer to generate frame and secure the bottom
steam. However, make sure of the bonnet to the frame
that the water tank is at least using the bottom tab (Fig. 3).
half way full for optimal results. Then attach the frame to the
garment steamer as described
above (Fig. 4).
IMPORTANT: Use caution
when changing the frames
10 TOLL FREE: 1-800-798-7398
GS500_series_IB_ES_100616.indd 10-11
™
Fig. 3
Fig. 4
Fig. 2 Fig. 5
when the unit is on, the Wrinkle
Eraser bar gets very hot. Use
™
the steam guard on the bottom
of the frame to remove safely.
T he small steam bonnet should
be attached to the unit at all
times during usage. Remove
the steam bonnet when the
unit has cooled for cleaning
only. The bonnet is permanently
attached to the bonnet frame
and should never be removed
from it.
T o remove the small steam
bonnet, remove the frame on
the unit if one is in place, then
gently pull on either side of
the steam bonnet and pull the
bonnet frame off the unit.
T o reattach the bonnet, gently
snap the frame over the steam
nozzle and press gently to lock
in place (Fig. 5).
Using the Press & Refresh and the Wrinkle Eraser
™
vertical press pad:
onto the fabric.
1 H ang the vertical press pad on CAUTION: Do not over tilt the
a door. (Fig. 1)
unit when steaming overhead.
2 H ang the garment that is to C AUTION: Do not hold the
be steamed onto the garment unit in a fixed position on
hook on the vertical press pad. delicate fabrics and upholstered
(Fig. 2) items.
3 O nce the selected accessory is 5 T he vertical press pad has two
placed on the fabric steamer, web hooks on either side. You
turn the On/Off switch to the can use these hooks to position a
"On" position, a blue LED garment for better results and a
light will illuminate (Fig. 3). larger pressing are when steaming
It will take approximately 1 sleeves. Use caution when holding
minute for the unit to heat up the sleeves of garments while
and be ready for steaming and steaming (Fig. 4).
pressing.
6 W hen steaming lightweight
4 H olding the fabric steamer in garments, pants and skirts
the vertical position with the you can use the Velcro
steam nozzle pointing away to hold the garment on the
from you, press and hold the vertical pressing pad.
steam trigger for continuous
7 W hen finished using the Fabric
steam and begin steaming
Steamer, turn the appliance
your garments in a vertical or
"Off" and let it cool before
horizontal motion. Begin at the
emptying the water tank and
top of the garment and move in
removing the bonnets and
a downward direction pressing
frames.
English
Hold the steam trigger
for continuous steam.
The steam will stop
emiting once you let
go of the button.
Intermittently wipe away
condensation from the
steam guard with extended
use
directly Using the Press & Refresh
™
horizontally:
8 T he Press & Refresh can be
used to deodorize, sanitize, and
refresh upholstered items: sofa,
baby bedding, mattress, car
seat, drapes, and more.
9 A ttach the upholstery/delicate
frame and upholstery pad to the
unit.
10 I n a horizontal position, move
the steamer continuously over
the upholstered item.
C AUTION: The Wrinkle Eraser ™
is hot. Use caution when
removing the frames. DO NOT
put your hands directly onto the
Wrinkle Eraser .
™
clips
™
W ARNING: Never steam any
article of clothing while it is
being worn.
www.sharkclean.com 11
10-06-16 11:46 AM