Stagnoli ENERGY Manual Del Usaurio página 18

Select the way of functioning
GB
In order to select the way of functioning
•take the system tension off (feeder cable relay)
•reactivate system tension by pushing the program-
ming switch (PG)
•push the button until the LED2 lighting
•during the last pressure, push the programming
switch (PG) a number of times which are necessa-
ry to select the modality you need. As soon as the
receiver memorizes the setting, LED2 will transmit a
fi x light signal and it will be possible to release the
button.
•in case the modality selections won't be ended properly, as the programming
time ends, LED1 and LED2 will blink in order to signal the reset of the previous
set modality.
* 1. remote load power saving : one pressure and one LED2 fl ash
* 2.impulsive signal : two pressures and two LED2 fl ashes
* 3.bistable receiver : three pressures and three LED2 fl ashes
* 4.crepuscular : four pressure and four LED2 fl ashes
Fix codes and variable codes
Energy works with fi x codes or, as an alternative, with variable rolling code tran-
smitters.
If the fi rst remote control is set with fi x code, the receiver will be able to register
only fi x code transmitters. On the contrary, if the remote control is set as variable,
the receiver will be able to register only variable-code transmitters.
N.B:
•Energy is supplied without a pre-set code.
•Rolling codes are set according to Stagnoli HCS coding, whereas fi x codes are
set according to Stagnoli Holtek 53200.
18
JUMP
LED1
LED2
LED3
PG