Stagnoli ENERGY Manual Del Usaurio página 19

Code-memorization and cancellation
GB
During the power-on phase, LED1 and LED2 will light
for two seconds according to the following settings:
•LED1 on: the rolling code is set
•LED2 on: the fi x code is set
•both LED on: no transmitter on the memory
As soon as the receiver is powered, push the pro-
gramming switch (PG) a number of times that are ne-
cessary to select the modality you need by keeping
on pushing the last input.
Possible operations related to pulses are:
• memory erasing : push the programming switch (PG)
only one time for 30sec. From now on, LED1 and
LED2 will start fl ashing and it will be possible to re-
lease the button. The erasing phase is concluded as
soon as the fl ashing ends.
• memorizing the fi rst-channel receiver : push two times the programming switch
(PG) going on pushing. LED1 fl ashes two times: push the receiver button you want
to memorize.
If the new code is recognized and memorized correctly, LED1 beams a long
signal.
By keeping pressure on the programming switch (PG), it is possible to memorize
further transmitters pushing (one at a time) the buttons of the new transmitters you
want to memorize.
• memorizing the second-channel receiver : push three times the programming
switch (PG) going on pushing. LED1 fl ashes three times: push the receiver button
you want to memorize.
If the new code is recognized and memorized correctly, LED1 beams a long
signal.
By keeping pressure on the programming switch (PG), it is possible to memorize
further transmitters pushing (one at a time) the buttons of the new transmitters you
want to memorize.
• erasing a transmitter code : push four times the programming switch (PG) going
on pushing. LED1 fl ashes four times: push the receiver button you want to erase.
19
JUMP
LED1
LED2
LED3
PG