Installing The Motor Onto Tomato Press - Weston 01-0101 Manual De Instrucciones

INSTALLING THE MOTOR ONTO
THE TOMATO PRESS & SAUCE MAKER
1. Making sure that the Tomato
Press & Sauce Maker is securely
mounted to the work surface, remove
the two screws from the neck of the
body. FIGURE 2
2. Attach Mounting Bracket
using the two screws that were
removed in #1. FIGURE 3
3. Insert the Bracket Mounting
Bolt through the hole in the Motor
Mounting Bracket. Attach the
Elongated Washer to the back of the
Bolt loosely.
4. Slide the Elongated Washer on
the Motor Mounting Bracket into the
large hole of the Mounting Bracket
by inserting the long end of the
Elongated Washer first followed by
the shorter end. FIGURE 4
5. Position the Motor Mounting
Bracket horizontally.
6. Using the supplied Allen Wrench,
tighten the Bracket Mounting Bolt
firmly, securing the Motor Mounting
Bracket to the Mounting Bracket.
7. With the Power Switch of the
Motor facing up, line up the Motor
Shaft with the drive hole on the and
rotate the Motor into place. Allow
the left side of the Motor to come to
rest on the Motor Mounting Bracket.
FIGURE 5
8. After Motor is positioned on the
Motor Mounting Bracket, rotate the
Movable Arm counter-clockwise so it
is positioned on the Motor. FIGURE 5
9. Once Motor is attached and you
haveverified the Power Switch is in
the off position (O), plug the unit into
the power source.
6
Neck
Neck
Enlongated
Washer
Mounting
Bracket
Motor
FIGURE 2
Remove
these
screws
FIGURE 3
Mounting
Bracket
FIGURE 4
Motor
Mounting
Bracket
Bracket
Mounting
Bolt
FIGURE 5
Movable
Arm
Motor
Mounting
Bracket