INSTALLING THE MOTOR ONTO THE PASTA MACHINE
WARNING!
Motor Attachment, make sure the Motor is in the OFF Position (O)
and the PLUG IS REMOVED FROM THE OUTLET/POWER SOURCE!
The 2-Speed Electric Motor eliminates
the need for the c-clamp when setting up
your pasta machine.
1. Position the pasta machine on your
work surface with the drive holes of the
rollers facing you. FIGURE 6
2. Locate the Motor Mounting Bracket
and lay it on the work surface in front of
the drive holes.
3. Insert the Bracket Mounting Bolt
through the hole in the Motor Mounting
Bracket and position it into the hole that
is used by the c-clamp. FIGURE 6
4. After aligning the Bracket Mounting
Bolt with the c-clamp hole, attach the
Elongated Washer to the back of the
Bolt. Using the included Allen Wrench,
securely tighten the Motor Mounting
Bracket to the pasta machine. FIGURE 6
5. Rotate the Movable Arm clockwise to
the far right. This will allow easy access
for Motor placement.
6. Hold the Motor with the Power Switch
facing up and the Motor Shaft pointing
toward the pasta machine.
7. Line up the Motor Shaft with the drive
hole on the pasta machine and rotate
the Motor into place, allowing the left
part of the Motor to come to rest on the
Motor Mounting Bracket. FIGURE 7
8. After Motor is positioned on the Motor
Mounting Bracket, rotate the Movable
Arm counter-clockwise so it is positioned
on the Motor. FIGURE 7
9. Once Motor is attached and you have
verified the Power Switch is in the off
position (O), plug the unit into the power
source.
8
Before cleaning, assembling or disassembling the
Drive
Hole
Enlongated
Washer
C-Clamp
Hole
Bracket
Mounting
Bolt
Motor
FIGURE 6
Drive
Hole
Movable
Arm
Motor
Mounting
Bracket
FIGURE 7
Pasta
Machine
Motor
Movable
Mounting
Arm
Bracket