Publicidad
Function • Funcionamiento
Functionnement • Funcionamento
1
IN
2
3
A
A
A
A -
3,9" (100)
6,7" (170)
6
2
6
7
Side view
Vista lateral
Vue de dessous
Vista lateral
4
1
2
S
S
OUT
4
5
2
1
3
4
3,9" (100)
H2O
3
24 h
english
The oil-contaminated condensate can
be discharged under pressure into the
ÖWAMAT oil-water separator. The
overpressure is reduced in the pres-
sure-relief chamber (1) without
creating turbulence in the separation
container. The calmed condensate
flows into the filter stage where it
passes slowly through the 2-stage
filter unit. Free oils and entrained dirt
particles are adsorbed in the
oleophilic prefilter (2). After this
preliminary cleaning of the conden-
sate, the residual mineral hydroca-
bons (mineral hydrocarbons are
removed in the activated carbon stage
(3). The clean water is discharged
through a riser (4).
INSTALLATION
Screw sampling cock (1) and hose
connectors (2) for inlet and outlet are
in tightly. Attach test device (3).
See enclosed assembly drawing!
Floor mounting
Use elongated holes of the 4 mounting
(4) feet. Screws and dowels supplied
with unit.Install the ÖWAMAT unit true
to plumb line (± 1°).
Wall mounting
Fix mounting brackets (6) perpendi-
cularly on the wall. Push in ÖWAMAT
with mounting area (5) and lock home
clamp (7).
Lay condensate feed line(s) along the
wall with a downward slope.
Lay water discharge line with a
continuous downward slope to the
wastewater discharge point. Install
siphon to avoid disagreeable smells.
The installation area must be such
that untreated condensate cannot
get into the public sewer system.
PUTTING INTO OPERATION
1. Remove cap and aerosol filter mat.
2. Fill fresh water into ÖWAMAT unit
until water comes out of the outlet.
3. Wait for 24 hours, top up with
water if required.
4. Put back cap and aerosol filter
mat.
The ÖWAMAT oil-water separator is
now ready for operation.
The outflowing water may initially look
black (carbon dust).
ÖWAMAT 1
Publicidad
