Audio Settings - PURE Evoke D2 Manual Del Usuario

Digital radio settings
Autotune
You can use the autotune function to automatically scan for new digital radio stations and remove inactive ones.
Note: Autotune is only available when you have selected 'Digital' as the radio source.
To carry out an autotune:
1. Press Menu.
2. Turn and press the Select dial to choose 'Autotune'. The number of stations found will be displayed
during the autotune.
When the autotune has finished, Evoke will tune to the last station that you were listening to.
FM settings
FM stereo option
You can choose between 'Stereo' or 'Mono' reception when listening to FM radio. You may want to choose
Stereo if listening using headphones.
Note: The FM stereo option is only available when you have selected 'FM' as the radio source.
To change between Stereo or Mono reception:
1. Press Menu.
2. Turn and press the Select dial to choose 'FM stereo'.
3. Turn and press the Select dial to choose between 'Stereo' or 'Mono' FM reception.
FM tuning mode
Press Menu and turn and press the Select dial to choose 'FM Tuning Mode'. Choose from the following
two modes:
Seek: When you turn the Select dial, the radio tunes to the next station with a good signal.
Manual: When you turn the Select dial, the radio tunes up or down the FM radio frequency range
by 0.05 MHz.

Audio settings

To adjust the bass and treble settings:
1. Press Menu.
2. Turn and press the Select dial to choose 'Audio'.
3. Turn and press the Select dial to choose 'Bass' or 'Treble'.
4. Turn and press the Select dial to set the level from -6 (low) to 6 (high).
12