Global Air NPC1-14C Manual De Usuario página 11

Installation Instructions
Assemble the Outdoor Adaptor
Align the two halves of the outer adaptor and gently snap together
Note: To prevent damage, do not use excessive pressure.
Install the Outward Adaptor and window slide Bar
1. Measure and verify if your window
kit fits the dimensions of your sliding
window.
If the kit is larger than your window
dimensions, it can be cut with a
saw or power tool.
If the kit is too short for your
window, you may order an
additional window kit from our online store to extend it.
2. Screw the slide bar connector into the exhaust hose.
3. Spin the exhaust hose into the air outlet located at the rear of the unit (counter-clockwise).
6. Make sure the adjustable slide bar fits your window and stays
in place.
7. Proceed to close and lock your window on the slide Bar.
Or Install directly through a wall/window
Cut a 150mm diameter hole in the wall or window, and then feed
exhaust hose through the window or wall.
4.
into the adjustable slide bar.
5.
width of the window (vertically or
horizontally), and then tighten the
screw to hold the length of the slide
bar.
11
Insert the slide bar connector
Extend its length to match the