Learning - One for All OARN05G Guia Del Usuario

1. Press and hold the device key (TV, SAT•CBL•DTC, DVD•VCR,
AUDIO, or AUX) whose code you wish to retrieve. The
POWER key illuminates. Keep pressing the device key.
2. While holding the device key down, press and hold the
INFO key. The POWER key illumination turns off. After
holding down both keys for three seconds, it turns back on.
3. Release both keys. The POWER key remains illuminated.
4. Starting with the number 1 key, press and release each
number key on the keypad in the following order: 1-9, then
0. The number that causes the POWER key to blink is the
first number of the code. As you find each number of the
code, write it down for future reference. Then start with the
number 1 key again.
5. Repeat step 4 until you have retrieved all five numbers in
the code. After the fifth number is retrieved, the POWER
key blinks briefly, then turns off.
Quick Code Reference
Device Type

Learning

Codes from the Code Lists include basic functionality for each
component they control. Once you have programmed in the
code for your specific component, you can customize the
universal remote to include certain functions from your original
remote(s) that were not embedded in the preset code. Your
universal remote has the ability to learn and store commands
from your original remote(s) under the mode(s) of your choice.
The universal remote can store up to 50 key commands.* Only
one original remote can be learned under any one mode (e.g.,
the universal remote can learn commands for one TV remote,
one VCR remote, etc.).
* Some learned signals require more memory than others. In
these cases, fewer key commands can be learned.
Before First-Time Learning
Before you start learning keys for the first time, clear any
stored learning information that might be in the remote. This
lets you begin with a clean slate.
1. Press and hold the EXIT key (the POWER key illuminates).
While you're holding down the EXIT key, use your other
hand to press and hold the POWER key (the POWER key
illumination turns off).
2. Wait until the POWER key comes on and stays on. Then
release both keys. The remote is now in the Master Clear
mode.
3. Press the OK key to confirm the Clear operation. The
POWER key remains on for 2 seconds, then turns off. All
Learned functions for all components are now cleared; all
other programming remains intact.
12
Code