Additional Information - One for All OARN05G Guia Del Usuario

• Make sure device is ready (for example, the DVD player has a disc
loaded).
• You may have pressed an invalid key for the mode the remote is in.
• If you're trying to enter a channel number directly, try pressing the
ENTER key after entering the channel number as this is a requirement
of certain models and brands.
• There is a possibility that a programmed code may only be able to
control some of your device features (for example, only turns a device
on and off). To confirm that the device key is programmed with the
correct code for maximum functionality, test the device. Attempt to
control a variety of the device's functions with the remote. If some of
the features of your devices don't work, try programming the remote
with a different code in the list using the Direct Code Entry Method,
until you find the code that allows the remote to control the majority
of your device's functions. Different codes can provide different levels
of functionality.
Problem: The POWER key does not illuminate when you press a key.
• You may have pressed an invalid key for the mode the remote is in.
• Make sure the remote is in the correct mode by pressing the
corresponding device key (TV, SAT•CBL•DTC, DVD•VCR, AUDIO, AUX).
This tells the remote which device to operate.
• Make sure the batteries are fresh and are properly installed. Replace
the batteries with three new AAA batteries, if necessary (see the
Battery Installation section).
Problem: The remote will not change channels on device.
• Make sure the remote is in the correct mode by pressing the
corresponding device key (TV, SAT•CBL•DTC, DVD•VCR, AUDIO, AUX).
This tells the remote which device to operate.
• Press the ENTER key after you enter a channel number.
• Remove any obstacles between the remote and the device. Make sure
to aim the remote at the IR sensor on the device.
Problem: The device's menu does not appear on the TV screen.
• Make sure you have connected the device to your TV properly and
selected the correct input. (See your devices' Owner's Manuals for
proper connection procedures.)
• Make sure the remote is in the correct mode by pressing the
corresponding device key (TV, SAT•CBL•DTC, DVD•VCR, AUDIO, AUX).
This tells the remote which device to operate.
• Menu access isn't supported for all brands. You may need to use your
original remote control to access menu functions for some devices.
Problem: The Learning process cannot be completed successfully.
• Replace batteries in both the learning remote and the original remote.
• Make sure the distance between the remotes is approximately 1–2 inches.
• Do not conduct the Learning process near an incandescent lamp.
• The learning remote's memory capacity may be full (50 Learned
commands).
• The original remote may not be compatible with the Learning
procedure.
For more information, please visit www.oneforall.com
Consumer Help Line: 1 (800) 315-0990

Additional Information

ONE FOR ALL® is the registered trademark of Universal Electronics Inc.
Audiovox Accessories Corporation is the Licensee of the ONE FOR ALL® brand
for North America.
© 2010 by Universal Electronics Inc. No part of this publication may be
reproduced, transmitted, transcribed, stored in any retrieval system, or
translated to any language, in any form or by any means, electronic,
mechanical, magnetic, optical, manual, or otherwise, without the prior
written permission of Universal Electronics Inc.
The One For All® 5-Device Universal Remote Control is compatible for use in
North America, excluding Mexico.
This One For All® 5-Device Universal Remote Control is covered by one or
more of the following US Patents:
6,587,067 6,496,135 5,515,052 5,959,751 6,587,067 5,481,256
OARN05G 1/10
16