Diamond AP50-PED/A Libro De Instrucciones página 10

Press on the hidden key at least five seconds, until the inscription "HYS", the label of the first
parameter, appears on the display.
At this point by pushing the "UP" and "DOWN" arrows you can look through the labels of
all parameters and when you have found the parameter that has to be changed, press on
the "SET" key again to display the value of the parameter, as it is possible to change it by
using another time the "UP" and "DOWN" arrows.
At the end of the change do not act on any keys for some seconds, so that the electronic
control panel can begin to work normally again.
If just at the beginning of the programming the label "PAS" appears instead of the label
"HYS", it means that a password, i.e. a numeric access code for the change of the parame-
ters, has been inserted. In this case the "SET" key has to be pushed and the code number
has to be selected through the "UP" and "DOWN" keys. By pressing on the "SET" key
again, the label "HYS" will appear and it will be possible to change the parameters.
In order to make the changes easier and to take always into account the programming of
the factory, we reproduce here below the table of the parameters.
N.B. Before making any change of the parameters, we suggest that the
user should apply to our technical department. Otherwise the company
disclaims all responsibility for the bad working of the unit.
9
GB
GB