Publicidad
Idiomas disponibles
Idiomas disponibles
Description of the electronic control panel controls and functions:
3
KEYS
KEYS
N.B. When power is supplied to the unit, the electronic control panel does a brief func-
tioning test; for this reason the leds and the display blink for some seconds. At the end
of the test, the electronic control panel switches off and it possible to execute the ope-
rations described later on.
1) "ON-OFF" Key:
2) "Cold room light" Key:
3) "SET" Key:
4) "UP" Key:
5) "DOWN" Key:
After having changed the setpoint, wait some seconds and the electronic control panel will
automatically begin to work normally again.
The "SET", "UP" and "DOWN" keys are used also for changing the programming parameters
(see the specific paragraph).
6) Hidden Key:
14
6
9
4
it is used for starting and stopping the electronic control panel.
Remember that even if it is off, the electronic control panel can be
anyway under voltage.
it is used for switching on and switching off manually the
cold room light (if it has been connected). The cold room
light can also work automatically, if a door microswitch is
connected to the corresponding enter and if the electronic
control panel is programmed correctly.
by pushing and releasing it, the setpoint of the thermostat is displayed.
In order to change this value push:
to increase the values of the setpoint.
If you press on it more than 5 seconds, a manual defrost is executed.
to decrease the values of the setpoint.
it is used for changing the programming parameters
(see the specific paragraph).
10
11
12
13
5
7
GB
GB
1
7
8
2
Publicidad
