Publicidad
Idiomas disponibles
Idiomas disponibles
CONNECT H EADLIGHT
- Connect wire harness terminals to
headlight assembly located u nder control
panel asshown i nthefigure below
• Tieheadlight cable toIower handles with
theplastic c able tiesupplied intheparts
bagbythreading thepointed e nds o fthe
tiethrough thesquare e ndand pulling
tightly a round t heheadfight cable and
handles. See figure below
NOTE: One side oftheplastic t iehassmall
notches init,while theother sideissmooth
The notched side must b eontheinside of
theloop which isformed w hen t heends are
puttogether..
Wire Harness
Headlight
Termina_
.__ Cable
Wire
Harness
Terrains
Cable Tie
\Lower
Handle
CONNECT
REMOTE
CHUTE
. Push remote chute control lever into
Up" _
position
"Chute Deflector
• Feed "Z" fitting through hole in remote
chute bracket as shown in figure below.
• Snap remote chute control cable into
remote chute bracket, see figure below
Remote '__
_ (_
Remote Chute
Chute
Control
/
\
Bracket
Bracket
_._ _-_ote
Chu,e
°Z"Fittin_
t Cable
• Connect "Z" fitting into remote chute
control bracket as shown in figure below.,
• Push remote chute control lever into
"Chute Deflector Down" "_ position,
• Cut tie strap on chute deflector as shown
in figure below
Chute
Dellector
INSTALL
MID-CHUTE
ROD
(set aside earlier)
•
Carefully remove cotter pin and clevis
pin from universal joint in the upper crank
rod as shown in first figure below.
NOTE:
If this removes the universal joint
and universal joint pin. Place universal joint
into yoke of upper crank rod lining up large
holes., insert universal joint pin (ensure
opening in universal joint pin is in line with
small openings in universal joint)
Upper
Clevis Pin
Rod
:rsal
Universal
Joint Pin
___//Cotter
Pin
, Place yoke of open end of mid-crank rod
around universal joint in upper crank rod.
Insert clevis pin through assembly and
secure with cotter pin, Spread ends of
cotter pin to lock in place See figure
below,
Mid-Crank
Red
'Crank
Rod
Publicidad
