BEA LZR-MICROSCAN T Manual De Instrucciones página 5

INSTALLATION
IMPORTANT:
• Refer to mounting template for full mounting instructions!
• Mounting height of 75" (min) to 98" (max) from finished floor to sensor LED.
Sensors
Do not apply sensor covers until system is fully operational. Do not adjust tilt angle.
1
Use Mounting Template to
position each sensor correctly.
Check for obstructions/clearance.
4
Using instructions on Mounting
Template, mount sensors with
appropriate screws.
7
Plug Master Sensor Harness into
hub port labeled Door A Sensors
NOTES:
1. Spacer required for applications with door hardware extending across width of door.
75.5753.14 LZR-MICROSCAN T 20180208 75.5753.14 LZR-MICROSCAN T 20180208
2
Align Mounting Template, and
then mark and drill holes.
on both sides of door. Be sure to
drill the correct size holes.
5
Plug in Slave Sensor Harness at
the upper most port on sensor.
8
If necessary, repeat steps 1 – 7 for
second door leaf using hub port
Door B Sensors.
3
Run Slave Sensor Harness through
Repeat door.
1
6
Install Door Loop: drill 1/2"
passage hole in header and jamb,
then route Master Sensor Harness,
and install the cap.
Page 5 of 16 Page 5 of 16