Loading The Ribbon Cartridge (Auto Cutter Model) - Star SP200 Serie Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 58
Ribbon feed
knob
Notched
part
A

Loading the Ribbon Cartridge (Auto Cutter Model)

Power off
Print head
Ink ribbon
Ribbon cartridge
B
Cover
3 Place the ribbon cartridge in the direction shown
in figure and press it down to load it. If loading
of the ribbon cartridge is not satisfactory, press
down the cartridge while rotating the ribbon feed
knob in the direction of the arrow.
4 Turn the ribbon feed knob of the ribbon cartridge
in the direction of the arrow to remove slack in
the ribbon.
5 Mount the cover by reversing the procedure
outlined in step 2 above.
Note: When removing the ribbon cartridge, raise
the A section and then remove it by holding
the B section as shown in figure.
1 Turn off power to the printer.
2 Lift the cover up approx. 3 cm. Hold the cover
tilted at this angle, then pull it toward you to
remove it.
– 7 –

Publicidad

Tabla de contenido
loading

Tabla de contenido