Testing The Installation - Hoover NEXTRA HNF6127 Manual De Instrucciones

40002005Eng.qxd 04/10/2004

Testing the installation

This
programme
will take
approximately
2 hours to
complete.
12
16:15 Page 12
Refer to the programme guide for details of how
to select programmes.
1.
Turn on the water supply and check for
leaks from the fill hose.
2.
Switch on the electricity supply.
3.
Select the spin programme
press the
Allow the programme to continue for one
minute and then cancel the programme by
returning the selector to the OFF position.
This will remove any water remaining in the
machine from factory testing.
4.
To check for cold water filling to the
machine:
Select the rinse programme
the button to start the machine.
Allow the tumble action to continue until
the water has pumped out. Check that the
drain outlet is not leaking or overflowing.
5.
Switch off the machine at the end of the
cycle by turning the programme knob to the
OFF position.
6.
Select the spin programme
the button to start the machine. If the
machine takes longer than one minute to
empty check the drain hose for kinks.
Installation testing is now
complete.
Now you have successfully installed the machine
we advise that you run the machine to ensure the
drum is thoroughly clean after testing and
storage. Select
complete cycle using only wash detergent and
water.
and then
button to start the machine.
and press
and press
90 and run the machine for a