Operation Procedure - Halley ELIBIKE 400 Manual Del Usuario

OPERATION PROCEDURE:

1: Installs 2 pieces of 1.5V #3 batteries, then the screen will display as following "Drawing A" and have "Bi" sound at the
same time, then enter to the personal data setting and press "MODE" button for confi rmation. After that, it goes to the
next step to the main menu as "Drawing B".
2: Get access to the set-up mode of TIME/DISTANCE/CALORIES/PULSE. When you are in each set- up mode, for example in
the time set-up mode, time value is blinking, you can press "UP and DOWN" button to adjust the value and press "MODE"
for confi rmation. The set-up of DISTANCE, CALORIES & PULSE is the same as TIME.
3: With any signal been transmitted into the monitor, the value of TIME, DISTANCE, CALORIES start to count up as Drawing C.
When there is any function has been preset the target (TIME or DISTANCE or CALORIES), the function will be counting
down from the preset to zero while the training starts. Once the target is achieved to zero, the monitor start to beep for
8 seconds, and the function will be counting up from zero directly if the training is going. Press "MODE" button for con-
fi rmation and skip to next set-up.
4: In SCAN mode shown as "Drawing C". RPM/SPEED/TM/DIST/CAL/PULSE will skip to display in every 6 seconds. The order
is as follows.
5: You can also press "MODE" button to select single function display except RPM & SPEED function. The RPM & SPEED
function will switch display.
Drawing A
6: RECOVERY
(1) When the user presses "RECOVERY" button, the RECOVERY function is active. At this time only PULSE and TIME is
working, other functions will not be displayed, and the Sensor Input is not available. TIME starts to count down
from "0:60", Pulse signal will be blinking according user's heart rate BPM. When Time counts down to "0", it will show
F1~F6. (F1 is the best, F6 is the worst).
(2) LCD display as follows: (RECOVERY start condition & end condition).
(3) If the count down action to 0:00 is not completed and there is no pulse signal, the count down action has to be
done and shown F6.
(4) If you press the RECOVERY button prior to count down to 0:00, it will be end and return to the main menu.
Note:
1 Stop training for 4 minutes, the computer will be off . You may press any button to have the computer restart working.
2 If the computer displays abnormally, please re-install batteries and try again.
3 Battery Spec: 1.5V UM-3 or AA (2PCS)..
Drawing B
ELIBIKE 400
Drawing C
23