Machine Set-Up - Amano American Sanders CE7 Pro Manual Del Usuario

EN
UNCRATE THE MACHINE
When the machine is delivered, carefully inspect the shipping
carton and the machine for damage. If damage is evident, save
the shipping carton so that it can be inspected. Contact the
American Sanders Customer Service Department.

MACHINE SET-UP

Fig. 1.1 OPERATING HANDLE
The operating handle provides control and comfort to the sanding
experience (all models). On models 07170A and 07176A, the handles
may be set to a greater height depending on preference. Remove the
4 screws securing the handle to the machine. Raise the handle until
the holes align then reinstall the 4 screws.
Fig. 2.1, 2.2 ABRASIVE DRIVER
The unit will accept either 7" (17.78 cm) hook and loop or 7" x 7/8"
(17.78 x 2.2 cm) center hole abrasive disc. Motion is delivered to the
abrasive through a replaceable spring steel sanding disc (11226A)
having a medium hook surface (39864A). The unique geometry
provides a flat finish and smooth sanding experience, reducing
objectionable scratches. The unit is equipped with a retaining screw,
washer, and onboard wrench for use with 7" x 7/8" (17.78 x 2.2 cm)
abrasive. When installing abrasive disc, take care to center disc on
driver.
NOTE: When using 7" x 7/8" (17.78 x 2.2 cm) abrasive, hold the
sanding disc while tightening the retaining screw. Do not over tighten
or removal will be difficult.
To avoid injuring the hook surface on the driver when sanding thick
paint, varnish or wax, it is recommended you stack two discs on the
driver using a course open coat abrasive.
Machine Set-Up
7
Figure 1.1
7" x 7/8" (17.78 x 2.2 cm) Mounting Hole
Figure 2.1
7" (17.78 cm) Hook and Loop
Figure 2.2