Publicidad
Idiomas disponibles
Idiomas disponibles
TO CHECK BRAKE
If tractor requires more than five (5) feet to
stop at highest speed in highest gear on a
level, dry concrete
or paved surface, then
brake must be serviced.
You may also check brake by:
1. Park tractor on a level, dry concrete or
paved surface, depress brake pedal all
the way down and engage parking brake.
2. Disengage
transmission
by placing
freewheel control in "transmission
disen-
gaged" position.
Pull freewheel
control
out and into the slot and release so it is
held in the disengaged
position.
The rear wheels must lock and skid when
you try to manually push the tractor forward.
If the rear wheels
rotate, then the brake
needs to be serviced.
Contact
a Sears or
other qualified service center.
FRONT
WHEEL
TOE-IN/CAMBER
Your
new
tractor
front
wheel
toe-in
and
camber
is set at the factory
and is normal.
The front wheel
toe-in
and camber
are not
adjustable.
If damage
has
occurred
to
affect
the factory
set front
wheel
toe-in
or
camber,
contact
a Sears
or other
qualified
service
center.
TO REMOVE
WHEEL
FOR REPAIRS
1.
Block up axle securely.
2.
Remove
axle
cover,
retaining
ring and
washers
to allow
wheel
removal
(rear
wheels
have a square
key - Do not lose).
3.
Repair
tire and reassemble.
TO START ENGINE WITH A WEAK
BAT-
TERY
_,WARNING:
Lead-acid batteriesgenerate
explosive
gases.
Keep sparks, flame and
smoking
materials
away
from
batteries.
Always wear eye protection
when around
batteries.
If your battery is tooweak
to start the engine,
it
should
be recharged.
(See "BA-N-ERY"
in the
MAINTENANCE
section
of this manual).
If "jumper cables" are used for emergency
starting, follow this procedure:
IMPORTANT:
Your tractor
is equipped
with
a 12 volt system.
The other vehicle
must also
be a 12 volt system.
Do not use your tractor
battery
to start other vehicles.
TO ATTACH
JUMPER
CABLES
-
1. Connect
one end of the RED cable
to the POSITIVE
(+) terminal
of each
battery(A-B),
taking
care not to short
against tractor chassis.
2. Connect
one end of the BLACK cable
to the NEGATIVE (-) terminal (C) of fully
charged battery.
3. Connect
the other end of the BLACK
cable (D) to good chassis ground,
away
from fuel tank and battery.
TO REMOVE CABLES, REVERSE ORDER -
1. BLACK cable first from chassis and then
from the fully charged battery.
2. RED cable last from both batteries.
Washers
Retaining
Ring
Axle Cover
I
'_Square
Key (Rear
Wheel Only)
NOTE:
On rear wheels
only: align grooves
in
rear wheel
hub and axle.
Insert square
key.
4.
Replace
washers
and snap retaining
ring
securely
in axle groove.
5.
Replace
axle cover.
NOTE:
To seal tire punctures
and prevent
flat tires
due to slow
leaks,
purchase
and
use tire sealant from Sears. Tire sealant
also
prevents
tire dry rot and corrosion.
26
D
Weak or Dead
Fully Charged
Battery
Battery
Publicidad
