How To Operate The Tuner; Tuning To A Station; Entering Stations Into Memory Automatically (The Automatic Preset Mode: Asm) - Eclipse CD1000 Manual Del Propietário

How to operate the tuner

ATTENTION
If stations have been stored in memory,
pressing a button from [1] to [6] will directly
select a station. (Refer to "Manually setting
stations into memory" on page 18.)
CAUTION
If the vehicle's battery is disconnected (for
repairs to the vehicle or for removing the
receiver), all stations in memory will be lost.
In such a case, set stations in the memory
again.

Tuning to a station

Press the [BAND] button to switch
1
to the desired FM, AM bands.
Radio bands will switch from FM1 ➔
FM2 ➔ FM3 ➔ AM in order each time
the button is pressed.
Press the [
2
start the automatic station search.
button:
[ ]
Starts searching toward higher
frequencies.
button:
[ ]
Starts searching
frequencies.
● MEMO ●
To tune to a station manually;
Press the [ ] or [
displayed. When "M" is displayed,
press the [ ] or [
station you want to listen to.
] or [ ] button to
toward lower
] button until "M" is
] button to select a

How to operate the tuner

ATTENTION
At times, it may be difficult to maintain optimum
reception because the antenna affixed to your
vehicle is in motion constantly (relative to the
broadcast antenna), encountering continuous
variation in the received radio signals' strength.
Other factors affecting
interference from natural obstacles, sign posts,
etc.
Entering stations into memory
automatically
(The automatic preset mode:
ASM)
ASM is available for the FM radio mode.
Press the [BAND] button.
1
You can switch the mode to desired
one.
2
Press the [FUNC] button.
Press the [3] button for several
3
seconds while [FUNC] is blinking.
The automatic preset mode starts.
[ASM ON] will appear on the display,
and stations are automatically entered
in memory under the buttons [1] to [6].
These buttons are called
buttons.
reception include
IV
V
preset
17