Position And Level The Tumbler; Installing Accessory Timing Cam - ALLIANCE JC50CG Manual Del Usuario

Position and Level the Tumbler

Remove lint panel door, and unscrew the four shipping
bolts (one at each corner). Remove tumbler from skid.
NOTE: Do not throw bolts away – they are the
leveling legs.
Remove four nuts from the literature packet and screw
one fully onto each leveling leg.
Screw the four leveling legs (bolts) back into the level
adjusting fittings from the bottom.
Slide tumbler to its permanent location. Adjust the
leveling legs until the unit is level within 1/8 inch
(32 mm). Tumbler must not rock. Lock leveling legs
with nuts previously installed.
IMPORTANT: Keep tumbler as close to floor as
possible. The unit must rest firmly on floor so
weight of tumbler is evenly distributed.
Figure 2
70268201
T483I
© Published by permission of the copyright owner – DO NOT COPY or TRANSMIT

Installing Accessory Timing Cam

Metered Models
Coin drop tumblers have eight accessory cams in the
literature packet. These allow you to change your
vending times. Refer to Table 1. Timer motor RPM is
printed on the timer motor.
Cam Pins
2
3
4
5
6
8
10
12
T483I
Installation
1/30 RPM 1/60 RPM
Timer Motor Timer Motor
15 30
10 20
7.5 15
6 12
5 10
3.75 7.5
3 6
2.5 5
Table 1
19