Victron energy BlueSolar PWM 12V 24V 5A Manual De Instrucciones página 6

Change settings in
Main display.
Press the MENU
button for several
seconds until the
display flashes, you
are in:
Battery Battery
type voltage
LEAD-
12.0V
b01 ACID
[24V]
[AGM]
LEAD-
12.0V
b02 ACID
[24V]
[Gel]
LEAD-
12.0V
b03 ACID
[24V]
[Wet]
12V
b04 12.8V
LiFePO4*
24V
b05 25.6V
LiFePO4*
*The controllers do not have a remote on/off input. Therefore use LiFePO4 batteries with integrated BMS only
(such as the Victron SuperPack batteries)
Press on the MENU
key again and you
are in:
Press on the MENU
key again and you
are in:
Main display: battery voltage, battery state of charge, charging
and discharging status.
Press MENU to enter next display.
Absorb Float
tion voltage
voltage
14.4V 13.7V
[28.8V] [27.4V]
14.2V 13.7V
[28.4V] [27.4V]
14.6V 13.7V
[29.2V] [27.4V]
14.2V 13.35V
28.4V 26.7V
Battery type setting.
See table below.
The factory setting is b01
Low voltage Low voltage
disconnect disconnect
factory range
setting
10.5V-12.0V
11.2V
in steps of
[22.4V]
0.1V
10.5V-12.0V
11.2V
in steps of
[22.4V]
0.1V
10.5V-12.0V
11.2V
in steps of
[22.4V]
0.1V
10.5V-12.0V
11.2V in steps of
0.1V
21.0V-24.0V
22.4V in steps of
0.1V
Low voltage disconnect
The factory setting is 11.2V [22.4V]
Low voltage reconnect
The factory setting is 12.6V [25.2V]
Low Low voltage
voltage reconnect
reconnect range
factory
setting
12.6V 12.0V-13.5V in
[25.2V] steps of 0.1V
12.6V 12.0V-13.5V in
[25.2V] steps of 0.1V
12.6V 12.0V-13.5V in
[25.2V] steps of 0.1V
12.0V-13.5V in
12.6V
steps of 0.1V
24.0V-27.0V in
25.2V
steps of 0.1V