Lock Setup; Lock Parts - Schlage BE468 Serie Guia Del Usuario

LoCk SetuP

Follow these steps to get your lock set up and ready to use.
If you would like to use a home automation system, refer to Z-wave Functions on page 10.
Decide what length you want the user Codes for the lock to be.
1
You can set User Codes to be from 4 - 8 digits in length. The default length is 4 digits. All User Codes must be the same length.
Any time you change the User Code length, all current User Codes will be deleted from the lock.
• See Change User Code Length on page 6.
Add/Delete user Codes.
2
The lock comes preset with two unique User Codes. You can either use these codes or remove them and program your own
codes.
• See Add User Code and Delete User Code on page 6.
Decide if you want to use the Auto-Lock feature or not.
3
When the Auto-Lock feature is enabled, the lock will automatically relock itself 30 seconds after being unlocked.
• See Enable/Disable Auto-Lock on page 7.

LoCk PARtS

Thumbturn
Schlage
Button
Touchscreen
Cylinder
Bolt
DOOR
EXTERIOR
Touchscreen
Schlage Button
• Used to lock and unlock manually from the inside.
• Located on the outside of the door.
• Press to exit programming mode immediately.
• The first button you will press when entering a user and in the
programming process.
• Located on the outside of the door.
• Used to enter codes for programming and unlocking.
• Remains unlit until the Schlage button is pressed.
• Used to unlock only in emergency situations. See Emergency Key
Override on page 9.
• Automatically extends and retracts when the touchscreen is used.
• Manually extends and retracts when the thumbturn is rotated.
DOOR
INTERIOR
Assembly
Touchscreen
Cylinder
Thumbturn
Bolt
3