Tabla De Contenido; Warranty And Fcc/Interference Statement; Register Your Product; Need Help - Schlage BE468 Serie Guia Del Usuario

Connected Touchscreen Locks
User Guide
Contents
Warranty and FCC/Interference Statement ..........2
Lock Setup ...........................................................3
Lock Parts ............................................................3
Replacing the Batteries .......................................3
Locking and Unlocking .......................................4
Locking from the Outside .....................................4
Locking from the Inside ........................................4
Unlocking from the Outside ..................................4
Unlocking from the Inside .....................................4
Cleaning the Lock ................................................4
Programming the Touchscreen ..........................5
Tips for Successful Programming .........................5

Warranty and FCC/Interference Statement

Lifetime Limited Mechanical and Finish Warranty and 3-Year Limited
Electronics Warranty
Subject to the terms and conditions of the warranty, Schlage extends a lifetime limited
mechanical and finish warranty and a one-year limited electronics warranty to the original
consumer user ("Original User") of our Schlage brand product ("Product") against defects
in material and workmanship, as long as the Original User occupies the residential
premises upon which the Product was originally installed. See answers.schlage.com
for specific warranty details and limitations, or contact Schlage Customer Service at (888)
805-9837 in the U.S. and Canada or (800) 506-7866 in Mexico for assistance.
FCC Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.

Register your Product

Document your purchase and register your
warranty at RegisterMySchlage.com.
2
2
Programming Descriptions ...................................5
Programming Procedures ...................................6
My Codes ..............................................................7
Best Practices ......................................................7
Default Codes Locations ......................................7
Record Your Codes .............................................8
Factory Default Reset ..........................................9
Emergency Key Override ....................................9
Z-wave Functions ..............................................10
About Z-Wave ....................................................10
Enrolling on a Z-Wave Network ..........................10
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may
cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
RF Exposure
To comply with FCC/IC RF exposure requirements for mobile transmitting devices, this
transmitter should only be used or installed at locations where there is at least 20 cm
separation distance between the antenna and all persons.
Under Industry Canada regulations, this radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry
Canada. To reduce potential radio interference to other users, the antenna type and its
gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not
more than that necessary for successful communication.
This Device complies with Industry Canada License-exempt RSS standard(s). Operation
is subject to the following two conditions: 1) this device may not cause interference, and 2)
this device must accept any interference, including interference that may cause undesired
operation of the device.

Need Help?

Visit our web site for videos,
FAQs and more: answers.
schlage.com
U.S.A.: 888-805-9837
Canada: 800-997-4734
Mexico: 018005067866