Cleaning The Lock; Programming The Touchscreen; Tips For Successful Programming; Programming Descriptions - Schlage BE468 Serie Guia Del Usuario

CLeANINg tHe LoCk

In order to properly clean the touchscreen from build-up of dirt, oils, or other contaminates; you should use a mild dish soap with warm water
and follow the general rules below:
• Do rinse the touchscreen with warm water prior to cleaning process.
• Do follow the application of soap with a damp, lukewarm cloth.
• Don't use abrasives, high alkaline cleaners, or gasoline.
• Don't leave cleaners on touchscreen for long periods, wash immediately.
• Don't apply cleaners in direct sunlight or at elevated temperatures.
• Don't use scrapers, squeegees or razors.
The bolt itself can be cleaned, using a mild dish soap and warm water. This can help improve decreased performance.

PRogRAmmINg tHe touCHSCReeN

Schlage Button
• The first button you will press
in the programming process.
• Can also be pressed to exit
programming immediately.

tips for Successful Programming

»
The lock comes preset with a unique default Programming Code
and two unique Default User Codes. Use these codes to operate
your lock or change them using the instructions in this guide.

Programming Descriptions

Add User Code
Delete User Code
Change Programming Code
Enable Vacation Mode
Disable Vacation Mode
Enable/Disable Beeper
Delete ALL User Codes
Enable/Disable Lock & Leave
Change User Code Length
Enable/Disable Auto-Lock
Temporarily Disable Auto-
Lock
Restore Auto-Lock
Green Check Mark
• Blinks when a number
key is pressed and
when a function is
complete.
User Codes unlock the deadbolt. Can be 4 - 8 digits long. All codes must be the same length. See Change User
Code Length on page 6.
Removes one User Code at a time.
The Programming Code is used to put the lock into Programming Mode. It is 6 digits long.
Prevents all user codes from unlocking the deadbolt. Enable for extra security while you are away for an extended
period of time.
Returns lock to normal operation.
The beeper can be turned off if desired. Beeps will still sound during programming.
Removes ALL User Codes from the lock.
When enabled: Press the Schlage Button to lock the deadbolt. (Default setting).
When disabled: Press the Schlage Button and then enter a user code to lock the deadbolt.
User Codes can be 4 - 8 digits in length. Default is 4 digits. Changing the User Code length will delete all
existing User Codes!
When enabled, the lock will automatically relock 30 seconds after unlocking. (Disabled by default.)
Auto-Lock must already be enabled. While the deadbolt is locked, press the Schlage Button and then enter a
4-8 digit User Code to unlock the deadbolt. Within 5 seconds, manually lock and unlock the deadbolt using the
thumbturn.
Lock the deadbolt using the thumbturn.
Red X
• If there is a problem during
programming, you will see
the red error X.
Programming Indicator
• Blinks when Programming
Mode is entered.
• Solid while a programming
function is being performed.
»
Default Codes are located on the back of the Interior Assembly.
5