Freud FT1700VCE Instrucciones De Operación página 11

c) Rotate collet until the spindle lock pin engages with the spindle (F). When the locking pin
engages, you will not be able to rotate the spindle. - Fig 1c
d) Using the included 22mm wrench (I), turn the collet nut (G) counterclockwise to loosen the
collet. - Fig 1d
e) Insert the router bit and rotate the collet nut with the 22mm wrench clockwise to
tighten the collet. Always be sure that 80% of the router bit shank is inserted in the collet
- Fig 1e
f) Rotate Locking Lever (R) until it disengages the Spindle Lock (N). Press the router base
release button and slide the router motor out of the base until the router bit is back below
the surface of the router base and close base clamp.
g) Before operating the router, follow directions in the section in this manual titled "Adjusting
Depth of Cut" to properly set your depth of cut.
h) To remove a router bit from the collet, follow steps b,c, and d and then remove the router bit.
WARNING: Failure to disengage the spindle lock or remove the wrench before operating this
power tool could result in injury or damage to the tool.
Fig. 1c
English
Fig. 1e
10
Fig. 1d