Programming - Master Lock NightWatch DEADBOLTS Guia Del Usuario

Programming

The deadbolt contains two factory-preset codes but can
be programmed to store up to a total of 20 additional
unique user codes. Codes can be added
and deleted at any time.
You'll need to know your administrative code before
beginning programming. It can be found on the label
on the inside front cover of your user's guide (page 2).
To begin programming:
Remove the upper interior cover (A).
Locate the "Program" button (B).
Programming an Entry Code
Press the "Program" button until the keypad on the exterior of the door
begins to flash blue. When it flashes blue you can release the button.
Enter your personal administrative code...
Push the
1-2
new code) and press
Type in a 4-10 digit code and again press
Re-enter your 4-10 digit code and again press
• If the keypad lights in green your new code has been confirmed
and added.
• If it lights red the code wasn't confirmed and you'll need to
repeat the steps again.
• If the keypad flashes red, the code was found in the memory
and is already an active code.
button (the function button for programming a
.
Enter
.
Enter
Enter
7
A
B
MO TO R
EX IT
PR OG RA M
.