Cadet RCP502S Guia Del Propietario página 4

1. The heater must be properly installed before
it is used. Be sure the plug fits tightly into the
receptacle. The red light indicates the unit is
plugged in.
2. Do not operate without the stand attached.
3. Do not use breaker panel or wall thermostat to
control heater.
How to Operate Your Heater
Select the "LOW" wattage setting. If your desired temperature is not reached, select the "HI" setting. NOTE: The temperature of the air
coming from the front of the heater will be approximately 40˚F warmer than the room temperature in the "HI" setting. With extremely
cold environments, air from the heater may not feel hot. As the heater continues to operate, the heater air and surrounding air tempera-
ture will continue to increase.
Fan cycling with heat
1. Press the ON/AUTO switch to the "AUTO"
position and turn the thermostat knob fully clock-
wise.
2. When the room reaches your comfort level,
turn the thermostat knob counterclockwise until
the heater turns off. The heat and the fan will au-
tomatically cycle around this preset temperature.
3. To reduce the room temperature, turn the knob
counterclockwise. To increase the room tempera-
ture, turn the knob clockwise.
About the Manual Reset Temperature Limit Control
The heater is protected by a high temperature manual reset control, designed to open the heater circuit and
stop the electrical current flow when excessive operating temperatures are detected.
Resetting the Manual Reset Temperature Limit Control
If the manual reset limit control has opened the heater circuit due to excessive operating temperatures, the
heater will not work or may blow cold air until the limit reset button is pressed. After allowing the unit to cool for
at least 10 minutes and resolving the problem causing the limit to trip (typically the heater is blocked or needs
cleaning); use a narrow object such as a ball-point pen to access the reset button through the lower-right hole
marked "RESET". Press FIRMLY. If the manual reset continues to trip, see Troubleshooting Chart.
For more effective and safer operation and to prolong the life of the
heater, read the Owner's Guide and follow the maintenance instructions.
Failure to properly maintain the heater will void any warranty and may
cause the heater to function improperly. Warranties are non transferable
and apply to original consumer only. Warranty terms are set out below.
LIMITED FIVE-YEAR WARRANTY: Cadet will repair or replace any Hot
One (RCP) heater found to be defective within five years after the date of
purchase.
These warranties do not apply:
1. Damage occurs to the product through improper installation or incor-
rect supply voltage;
2. Damage occurs to the product through improper maintenance, misuse,
abuse, accident, or alteration;
3. The product is serviced by anyone other than Cadet;
4. If the date of manufacture of the product cannot be determined;
5. If the product is damaged during shipping through no fault of Cadet.
6. The use of unauthorized accessories or unauthorized components
constitutes an alteration and voids all warranties. Refer to Cadet website
or call customer service at 855.CADET.US for list of authorized accesso-
ries and components.
7. CADET'S WARRANTY IS LIMITED TO REPAIR OR REPLACEMENT
AS SET OUT HEREIN. CADET SHALL NOT BE LIABLE FOR DAMAGES
SUCH AS PROPERTY DAMAGE OR FOR CONSEQUENTIAL DAMAG-
ES AND/OR INCIDENTAL EXPENSES RESULTING FROM BREACH
OF THESE WRITTEN WARRANTIES OR ANY EXPRESS OR IMPLIED
WARRANTY.
Page 4
OPERATING INSTRUCTIONS
Fan running continuously with intermittent heat
Determined by the thermostat setting
1. Press the ON/AUTO switch to the "ON" position and turn
the thermostat knob fully clockwise.
2. When the room reaches your comfort level, turn the
thermostat knob counterclockwise until the heater turns
off. The heater will automatically cycle around this preset
temperature, however the fan will run constantly.
3. To reduce the room temperature, turn the knob counter-
clockwise. To increase the room temperature, turn the knob
clockwise.
Resetting the Manual Reset Limit Control
Warranty
4. Always unplug heater when not in use.
5. Clean heater at least every six months or as
required. See "MAINTAINING YOUR HEATER".
6. CAUTION: Risk of electrical shock. Do not
open. No user-serviceable parts inside. Any
other service not detailed in this owner's guide
should be performed by an authorized service
representative.
8. IN THE EVENT CADET ELECTS TO REPLACE ANY PART OF YOUR
CADET PRODUCT, THE REPLACEMENT PARTS ARE SUBJECT TO
THE SAME WARRANTIES AS THE PRODUCT. THE INSTALLATION
OF REPLACEMENT PARTS DOES NOT MODIFY OR EXTEND THE
UNDERLYING WARRANTIES. REPLACEMENT OR REPAIR OF ANY
CADET PRODUCT OR PART DOES NOT CREATE ANY NEW WAR-
RANTIES.
9. These warranties give you specific legal rights, and you may also
have other rights which vary from state to state. Cadet neither assumes,
nor authorizes anyone to assume for it, any other obligation or liability in
connection with its products other than as set out herein.
If you believe your Cadet product is defective, please contact Cadet
Manufacturing Co. at 855.CADET.US, during the warranty period, for
instructions on how to have the repair or replacement processed. War-
ranty claims made after the warranty period has expired will be denied.
Products returned without authorization will be refused.
Parts and Service
Visit cadetheat.com/parts-service for information on where to obtain parts
and service.
Reduce-Reuse-Recycle
This product is made primarily of recyclable materials. You
can reduce your carbon footprint by recycling this product at
the end of its useful life. Contact your local recycling support
center for further recycling instructions.
Fan running
continuously
with no heat
1. Press the
ON/AUTO
switch to the
"ON" position.
2. Turn the ther-
mostat knob
just above the
"OFF" position.
Manual Reset Limit Button