Genicom 5000 Serie Guía De Referencia Rápida página 20

5000 Series Quick Reference Guide
6. To accommodate a different width of paper, release the right tractor
lock by pushing down on the small black lever. Load the paper onto
the tractor pins and close the tractor door. Slide the tractor to the
right to remove slack, then lock the tractor again and close the door.
Refer to Top View illustration in Step 2, page 12, for location of the
tractor locking lever on the 5180 model.
• If another type of paper has been loaded, use the following
guidelines for the proper settings of the print gap and paper
tension:
Tractor Lock Lever
•
Set the print gap wheel to 1 for single-part paper or 2 for two-
part paper. For additional information on setting the print
gap, see the section, "Print Gap Adjustment," in the User's
Manual.
Decreases Print
Gap
• Set the paper tension lever to 1 for single-part paper and 2 or
higher for multi-part forms.
Because of humidity and the weight of the paper, you may have to
change the above settings to obtain the best print quality. For
paper specifications, see Appendix B in the User's Manual.
7. Press the TOF key on the control panel.
8. At this point the message Paper Jam may be displayed. Press the
Clear key on the operator control panel to clear this display.
Note
19 GEK-99012D