Power And Control Unit; Operation; Before First Use - Aquabot Top Access Guia De Inicio Rapido

Components

Power and Control Unit

The power and control unit is
connected to the robotic
1
cleaner via the floating cable.
The unit is powered by AC
power (1) and supplies low
voltage and commands to the
cleaner unit through the outlet
socket (2).
The unit features a control
panel (3) with various controls
to operate the robotic cleaner.
Contents of Packing Box
The robotic cleaner is packed in a box containing:
- Robotic cleaner and floating cable
- Power and control unit
- User manual
According to the model purchased, the following accessories may be included
in the package:
- Remote Control
- Caddy
- Trolley
- Additional Accessories
3
2

Operation

Before First Use

Adjusting Suction Height: Positioning the suction inlet (2) close to the pool
surface increases the suction power and the cleaning quality. Lowering the
suction inlet could result in interference with obstacles on the swimming
pool floor or walls.
Use a screw driver to adjust the suction inlet position knob (1).
- IN – pulls the suction inlet away from the pool surface and reduces the
suction power.
- OUT – brings the suction inlet closer to the pool surface and increases the
suction power.
Adjusting Floating Handle
On wall climbing models, set the floating handle:
1. Press the lock button (1 or 2 according to the model) to release the handle
lock.
2. Place the handle (3) diagonally at maximum position.
3. Repeat steps 1 and 2 on the other side of the cleaner unit.
Handle lock horizontal
Handle lock vertical
1 2
2
1
3
5