Maintenance; Cleaning Filters; Storing The Robotic Cleaner; Checking Water Outlet Propeller - Aquabot Top Access Guia De Inicio Rapido

Maintenance

2
1
3 4
5 6
shutter
7
Cleaning the Filters
The two filters must be cleaned after each cleaning cycle.
1. Release the filter and pull it out of the cleaner unit. (1), (2)
2. Pull the filter door against the filter housing to open the filter case. (3), (4)
3. Spray water on the outer sides of the filter and then spray water towards the inner side of the
4. Verify that the small plastic shutter (2) is in place and not broken, then close the filter. (6)
5. Insert the filter back into its location until a click is heard to secure the filter in place.(7), (8)

Storing the Robotic Cleaner

Follow these instructions to store the robotic cleaner when not in
use:
1. Disconnect the power cord from the wall outlet.
2. Disconnect the floating cable from the power and control unit.
3. Spread out the floating cable and release any twists in the
4. Wash the cleaner unit interior space with fresh water and let it
5. Roll the floating cable and place it ON THE CLEANER unit.
Caution: DO NOT ROLL the floating cable ON THE HANDLE
of the cleaner unit.
6. Store the robotic cleaner components in a dry, closed location.
7. Verify that the power and control unit is not exposed to water.

Checking Water Outlet Propeller

It is recommended to periodically clean debris
and hair from the propeller of the water outlet:
8
1. Remove the screws (3) that holds water outlet
2. Remove the water outlet cover (2).
3. Clean any hairs, dirt, or debris.
4. Verify that the propeller (1) is not broken.
5. Return the cover (2) and fasten it with the
filter to clean all the dirt and debris. (5)
cable.
dry.
cover(2).
screws (3).
3
2
1
8