Victron energy PPP-8 Manual Del Usuario página 9

Pin DIN Name
1 L Left Turn Signal
2 Rear fog lamps
3 31 Ground(-) for pin 1 - 8
4 R Right Turn Signal
Tail, side, registration
5 58R
6 54 Stop lamps
Tail, side, registration
7 58L
8 Reversing lamps
9 30 +12 V permanent
+12 V via ignition lock
10 15
11 31 Ground (-) for pin 10
Trailer present
12
13 31 Ground (-) for pin 9
Pins 9 or 10 with their respective Ground returns (11 or 13) can
be used.
Normally, pins 9 and 10 are fused at 20 A in the car's fuse panel.
The advantage of using pin 10 is that the PPP only charges when
the ignition is on, so the car's battery doesn't drain when parking.
Pin 10 is a non-standard option on most car models, so please
verify it's available.
If connected to pin 9 be careful not to drain the car battery when
the engine is not running. Disconnect the trailer plug on longer
stops.
Most absorption type refrigerators use up to 10 A. When the PPP
is added on the same circuit, the 20 A fuse is not overloaded but
there is no available power for other loads. When other loads are
used, such as the water pump or lamps, the refrigerator must be
switched to gas power.
Cable size
Color
mm
Yellow 1.5
Blue 1.5
White 2.5
Green 1.5
Brown 1.5
Red 1.5
Black 1.5
Pink 1.5
Orange 2.5
Grey 2.5
Black/White 2.5
Light Grey 1.5
Red/White 2.5
2
AWG
15
15
13
15
15
15
15
15
13
13
13
15
13
7