EMOTION BH EVO Manual Usuario página 37

EASYGO / EVO / NITRO / AWD
2. Switching the Pedal Assistance System on and off.
The pedal assistance system is turned on by holding down the POWER button for 3 seconds. The pedal
assistance system is turned off by holding down the POWER button again for 3 seconds. The bicycle can
be used normally without any type of assistance.
WARNING
NOTE
3. Pedal Assistance Mode Selection.
The system has 5 pedal assistance modes:
100% or BOOST
70% or SPORT
50% or NORMAL
30% or ECO
0% or NO ASSIST
To toggle through the assistance modes, the user must press the (+) button to increase the level
of assistance and the (-) button to reduce the level of assistance.
NOTE
3 sec
After turning the system on, make sure that you do not start riding without
checking the assistance mode. By default, it starts with the assistance mode
selected before it was last switched off.
Wait 3 seconds after turning on the system before you start applying pressure
on the pedals. During this 3-second period, the assistance system is starting
up and calibrating the torque sensor. Otherwise, if you press the pedal
beforehand, this may weaken assistance and error 14 may even be displayed
on the screen (see Troubleshooting section). To fix this, you should reboot the
system without applying pressure on the pedals for a period of 3 seconds.
Use when you want to get maximum power from the system.
Use when climbing difficult terrains.
Use when you want a more comfortable ride, e.g. when climbing a steep heel.
Use when you want to travel as far as possible.
Use when you want to travel without assisted power. You can continue to use
the other functions of the display panel.
During a journey, selecting suitable assistance modes for the terrain and
pedalling conditions that you encounter will ensure the best balance between
battery economy and pedalling comfort.
USER MANUAL
EN
37