IFM CR7021 Manual De Instrucciones página 25

SafetyController CR7021
Control systems
CR7021
Digital/analogue inputs
▲ %IX0.00...07
▲ %IW03...10
can be confi gured as:
Digital inputs
– %IX0.08...11
can be confi gured as:
Digital inputs
▲ %IX0.12...15
can be confi gured as:
Digital inputs
▲ %IX1.04...07
can be confi gured as:
Digital inputs
▲ %IX1.08...15
can be confi gured as:
Test input
Observe the special notes in the
system manual "SafetyController".
▲ = safety-related
ifm electronic gmbh ● Friedrichstraße 1 ● 45128 Essen
14
Digital inputs for positive sensor signals (B
Switch-on level
Switch-off level
Input resistance
Input frequency
Voltage/current inputs (A)
Input voltage
Input current
Resolution
Accuracy
Input resistance
Input resistance
Input frequency
Digital inputs for positive sensor signals (B
Switch-on level
Switch-off level
Input resistance
Input frequency
Digital inputs for positive sensor signals (B
Switch-on level
Switch-off level
Input resistance
Input frequency
Frequency inputs for positive sensor signals (I
Switch-on level
Switch-off level
Input resistance
Input frequency
Digital inputs for positive sensor signals (B
Switch-on level
Switch-off level
Input resistance
Input frequency
Frequency inputs for positive sensor signals (I
Switch-on level
Switch-off level
Input resistance
Input frequency
Digital inputs for positive/negative sensor signals (B
Switch-on level
Switch-off level
Input resistance
Input frequency
The test input must be active if for example software is to be loaded to the controller
(pin 24 to VBB , 10...32 V DC).
S
Safety-related outputs (MODE byte OUT_Safety) cannot be used with an active test
input. To have them available again the test input must be deactivated and a reset must
be carried out.
(Reset = power off/on of the controller)
While the machine is in operation the test input must be connected to GND.
Input resistance
Observe the notes on the confi guration of the inputs/outputs!
(→ system manual "SafetyController")
Frequency inputs are only safety-related if combined!
We reserve the right to make technical alterations without prior notice!
Characteristics of the inputs
)
L
0.7 U
B
0.4 U
B
30 kΩ
50 Hz
0...10/32 V
0/4...20 mA
12 bits
±1.0% FS
50/30 kΩ (voltage)
400 Ω (current)
50 Hz
)
L
0.43...0.73 U
B
0.29 U
B
3.21 kΩ
50 Hz
)
L
0.7 U
B
0.4 U
B
2.86 kΩ
50 Hz
), evaluation with integrated comparator
L
0.43...0.73 U
B
0.29 U
B
2.86 kΩ
≤ 30 kHz
)
L
0.7 U
B
0.4 U
B
3.21 kΩ
50 Hz
), evaluation with integrated comparator
L
0.43...0.73 U
B
0.29 U
B
3.21 kΩ
≤ 1 kHz
)
L/H
0.7 U
B
0.4 U
B
3.21 kΩ
50 Hz
3.21 kΩ
CR7021 / page 5 23.08.2017