Overview; Installation And Operation - Compucessory CCS70003 Manual De Usuario

overview

1. Standby / emergency stop button
2. forward in feed
3. In feed for Cds/dvds/credit cards
4. In feed for paper
5. Main switch
6. Collection unit for Cds etc.
7. Collection unit for paper

Installation and operation

• Place the equipment on a flat and even surface.
• Make sure that the equipment is placed away from any radiators or hot areas.
• Do not cover the cooling vent at the rear of the equipment.
• Avoid the use of extension cables and multiple power sockets if possible, and connect the equipment directly to a
wall socket (as specified in the section on technical information).
• Please keep the equipment at a distance of at least 4 inches away from the wall in order to ensure the cooling vent
has an adequate supply of air.
operation
Switch on the power button at the rear of the machine ("ON"). The symbol for standby mode which is displayed as
("Standby") will light up and the machine will go into standby mode.
The equipment is now ready to use. Should the symbol not light up, then please refer to the section "General
Troubleshooting" on page 5 of this manual.
Shredding paper
Place the paper in portrait orientation into the corresponding in feed unit. The paper will be recognized by the
sensors, and the cutter will begin to feed the paper through automatically. The equipment will stop once
again after a short period when no paper has passed through the cutter. When no sheets of paper have been
fed through for a period of three minutes, the equipment will revert to standby mode and have minimal
power consumption.
Please press the
Please be aware of the maximum number of sheets of paper. Further information can be found on the device,
or in the table below entitled "Product Specification".
overloading
If you overload more paper in one go than the machine is able to handle, the overloading display will turn to
red, and the cutter will stop immediately. Should this happen, then please reduce the number of sheets and
try again. Should this particular fault not be rectified automatically, then press the up arrow
remove any paper. The machine will then be reset to either normal or standby mode.
button to switch from standby to operational mode.
8. Casters
9. removal tray (handle)
10. overheating light
11. Overflow light
12. reverse in feed
13. Cooling vent
14. Mains power supply
3
in order to