Tripp-Lite SRCOOLNET Instalación Y Guía De Inicio Rápido página 3

Installation
2 - Dynamic IP Address Assignment
Connect the SRCOOLNET to the SRCOOL12K or SRXCOOL12K: Using the
2-1
dedicated connector
the side of the spot cooler (See Figure 1 on Page 5).
Connect SRCOOLNET to Power: Connect the AC Adapter
2-2
via the port labeled "DC Power"
source (See Figure 1 on Page 5).
Note: The SRCOOLNET must be plugged into a power source protected by a
UPS or Inverter/Charger in order to maintain communications during a power
outage.
Connect SRCOOLNET to Network: Connect a standard Ethernet patch cable to
2-3
the RJ45 Ethernet port on the SRCOOLNET. Note: This port does not support
PoE (Power over Ethernet) applications. The SRCOOLNET will attempt to obtain
an IP address via DHCP . This may take as long as several minutes, depending on
your network environment.
Discover IP Address: Contact your network administrator to determine which IP
2-4
address has been assigned to the SRCOOLNET by the DHCP server. The card can
be identified on the DHCP server by referring to its MAC address (see Step
You may wish to request a long-term lease period for the IP address, depending
on your application. After you have discovered the IP address, proceed to
4 - Test and Configure. Note: The DHCP address is also displayed during boot-
up when connected to a computer through the configuration cable and a
terminal emulation program.
13-08-187 93-32CA.indb 3
A , connect the SRCOOLNET to the communication port on
C and plug the other end into an AC power
3
B to the SRCOOLNET
1-2 ).
9/27/2013 9:25:19 AM